FOR EXTERIOR & INTERIOR SURFACES
Surface-applied water-repellent treatment for the protection of concrete, cement stucco, mortar, brick, and artificial & natural stone.
Couldn't load pickup availability
Hydro Guard does not add a sheen or gloss post-application. Your treated surface will retain its natural color and low gloss.
Unlike traditional sealants or coatings, Hydro Guard creates a water-repelling near-surface zone without sealing substrate pores. If there is water or leakage behind the Hydro Guard-treated surface, water can evaporate through those open pores, permitting drying and preventing swelling and cracking.
After applying Hydro Guard, it starts working 24 hours after its dry! Protection comes from the inside out, making your surfaces water-resistant! Protect your horizontal and vertical surfaces from water ingress and water damage! If your site is located in an area with weather, protect surfaces from the damage of a freeze/ thaw cycle!
Hydro Guard’s is a non-toxic and water-borne formulation and is resistant to UV radiation, thus preventing surfaces from yellowing over time.
Hydro Guard is formulated for absorptive vertical surfaces and horizontal hardscapes like concrete walkways.Â
You can apply Pure Guard to the following substrates:
With the proper care, Hydro Guard can provide long-term protection. Application is simple and you can even do it yourself.
We have helpful downloadable guides for applying for specific substrates. Below, you can find the application guide for applying Hydro Guard.
VIEW APPLICATION GUIDE (PRINTABLE)
(Some links may contain affiliate links)
NOTE: ON NEW BUILDING SURFACES AND INSTALLED REPAIR MATERIALS, ENSURE SUBSTRATE IS FULLY CURED PRIOR TO APPLICATION.
DO NOT DILUTE PRODUCT. SHAKE CONTAINER WELL BEFORE USE. LOAD PUMP SPRAYER OR PAINT TRAY AFTER MIXING WELL.Â
Surface and air temperatures must be at least 41°F (5°C) during application and for 8 hours following and should not exceed 95°F (35°C). Do not apply by sprayer in windy conditions to prevent loss.
Apply Hydro Guard to the point of rejection using a brush, roller, or airless sprayer. No dilution is required. On very absorptive surfaces, re-apply within 3 hours to increase penetration depth. Testing is recommended on a small inconspicuous area before full-scale application. Surface water-repellency is typically achieved 24 hours after application.
BY SPRAYING
Saturate from bottom up. Apply enough for a 4-8in rundown below the spray contact point. Let first application penetrate for 5-10 min before applying second coat. NOTE: When spraying fluted architectural block, spray in an overlapping X-pattern. Wipe up any excess material using microfiber cloths.
BY BRUSH / ROLLER
Only for small scale applications. Apply uniformly and saturate the surface. Let product penetrate for 5-10 min. Brush out heavy runs and drips that do not penetrate.
We recommend applying to horizontal surfaces using a sprayer. Apply in a single-saturating coat. Do not over-apply. Back roll out any puddles thoroughly until they penetrate the surface. Wipe up any excess material with a microfiber cloth.
Avoid waterproofing membranes, sealants and coatings that can affect the final aesthetic of your building façade and choose Hydro Guard!
Our nano-formulation requires no dilution. Just clean exterior stone or masonry surfaces, allow the surface to dry. Shake well and spray Hydro Guard and Pure Guard onto surfaces using an HVLP or pump sprayer!
With Armus nano-formulations, our products do all the heavy lifting for you! Pure Guard not only breaks down surface pollutants on a building’s exterior, but also helps to break down pollutants in the air as well!
Interested in this product? Please fill out this form and we'll send you more details.
Application Guide